Kitty Garden Logo

Seam position

For all kitty models

For the best visual quality of your kittens, make sure to set Seam position parameter to Rear.

Wood filament

General tips

Wood filament is a tricky piece of poop 🙂 With some filaments, you can get away with base settings but In this project, I had to challenge one of the most frustrating ones. In my practice, I found a few general tips on how to print wood filaments well.

  1. Use 0.6 mm nozzle. In some cases, you can get away with 0.4mm but using a larger nozzle will save you 99% of frustration.
  2. Disable retraction.
  3. Use 210°C temperature.
  4. Reduce your speed. Just be sure, not to exceed 40mm/s.
  5. Use standard 1.0 flow rate.
  6. Clean your nozzle after every print. I usually unscrew the PTFE filament tube and push the standard filament directly through the nozzle a few times. You can do additional cold pull for good measure.